New 3D printer Wanhao Duplicator 4S
1 Item Items
Warning: Last items in stock!
|Print Technology||FFF Fused Filament Fabrication|
|Build Volume||225 X 145 X 150mm|
|Layer resolution||100 microns|
|Nozzle Temperature||MAX 230°C|
|Heat bed temperature||MAX 120°C|
|Filament diameter||1.75 mm|
|Connectivity||Print with SD Card or direct via USB Port|
|File type||STL and G-Cod|
|Nozzle diameter||0.4 mm|
|OS Support||Linux / OSX / Windows|
|Product dimensions||320 x 466 x 382 mm|
The Duplicator 4s has our latest dedicated 1.75 mm filament extruder. This extruder was designed from scratch, and contains a number of custom manufactured parts. We've learned a lot over our past extruder designs, and incorporated a lot of those lessons here: that's why it's smaller, lighter, and faster to build. And since it's designed from the ground up for 1.75 mm filament, it's light-years ahead of past designs in small-filament reliability. The layer alignment is much better which results in nicer prints and higher resolution, 100 micron inch. We've completely overhauled the drive system to give the optimum positioning accuracy. The entire system has been upgraded to sturdy 3/8? diameter linear shafting. This is probably overkill, but you can trust that the axes will be sturdy. We've also switched to self-aligning, sintered stainless steel bearings. These are very forgiving to DIY assembly and provide a nice, smooth motion on the steel shafts. We've completely replaced the Z axis with a stepper driver, centilevered stage. Guided by two of the linear shafts, this completely eliminates any Z wobble and results in nicely aligned layers. Using a high-angle lead screw, we were able to increase the speed of the Z axis from 150mm/minute to 1,000mm/minute. This means the layer changes are almost completely imperceptible.
Connect over USB and hit print - the machine will calibrate itself and start printing. The new electronics have been designed to make the printing experience easier than ever. The Duplicator 4s connects to your computer via a standard USB cable thanks to a USB chip on the motherboard. We've also added full end stop support so that you never need to touch the XYZ axes ever again. When you hit print, the machine will automatically home itself, heat up, and begin printing. All you have to do is sit back and relax while your Duplicator 4s does all the work. Living in the future is awesome. Oh yeah, and the electronics are all inside, so you don't have wires dangling everywhere.
Or you can print with SD card. Sometimes customer failed in printing with computer USB link, due to the computer sleep or shut down automatically. For this reason, we developed SD card reader on printer. Awesome, all your printer job can be done by this small card. 2Gb card is sufficient for any 3D file and keep as many file as you like. Simple and fast is our mission.